How to repair the edge sealing machine common problems

Edge sealing machine professional manufacturers based on years of practical experience summed up the edge machine in the use of the problem of how to repair, the following brief introduction:

1. Can judge by themselves, simple maintenance to save time, bring greater use benefits. The edge sealing machine has a screw loose resulting in unstable trimming. Find the base, tighten the screws, and adjust the tool.

2. Problems in pressing part lead to abnormal work of trimming and polishing equipment. If the plate is not pressed tightly, or there are high and low before and after the pressing material vertical plate, when the plate moves to the gluing part, the coating wheel and the pressing wheel exert a certain pressure on the side of the plate, resulting in the displacement of the plate from the baseline, resulting in the subsequent process can not be completed. Solution: the plate is pressed, and the tightness is the same before and after, and then the reference ruler and copy wheel of the trimming tool on the plate to adjust the tool until the ideal effect.

3. Edge sealing machine repair datum did not find the plate surface. The edge trimming knife can accurately trim the edge strip out the ideal line thanks to the horizontal ruler and vertical ruler beside the edge trimming knife. If they are not close to the plate in progress, it is bound to be unable to repair the appropriate line. Solution: the board that will be a long flat end face and into the edge banding machine, when can the plank to cover polishing, scraping edge, fine and coarse trim this position will stop conveyor belt, based on the plate to the above mentioned horizontal and vertical benchmark depend on the board, the tool cutting edge near the plate edges, waiting behind fine-tuning until the ideal effect.

The above is how to maintain the edge sealing machine common problems.